Product Description
Header Pipe for small block engines.
FITMENTS:
- TILLOTSON 196, 212, 225
- PREDATOR 212
- 196CC HONDA CLONES
- HONDA GX200
The end of this header pipe flares out to 1-5/16".
We strongly recommend using the Header Support to prevent pipe from breaking.
Product Videos
Custom Field
Product Reviews
109 Reviews Hide Reviews Show Reviews
-
Probably my favorite pipe!
Absolutely love the sound of these pipes, outta all my exhaust I alway go back to this one
-
Trash waste of Money !
Seemed solid but when you looked in side there were dingle Berries from the weld. Went to mount it took it for 1st ride and the pipe cracked right at the weld. Will not be ordering products from here again.
-
doesn’t work on...
i saw “ Justin moran “ fit his under the review, not sure if i have to cut anything down
-
Center Exit...
FYI This pipe will not fit the Mega Moto 80 with an engine riser plate and a 212 .
-
Question
DOES THIS WORK FOR THE TRAILMASTER HURRICANE ??
-
Had some popcorn welds on the flang and tip of...
Had some popcorn welds on the flang and tip of exhaust was cut crooked
-
Header Pipe, 3 Stage Center Exit 196/212
Header Pipe, 3 Stage Center Exit 196/212
-
Header...
This was my first build so first exhaust it looks and fits well sounds good to me but your neighborhood may not think the same as it is loud but if that is what your looking for great peice
-
Excellent!
Works awesome on a predator in a coleman bt200x get some header tape and your good 2 go!
-
3 Stage Header...
Awesome pipe. I tried this pipe on a 196cc stock engine just to see what it did. Nice power increase on the low end and no loss on top end. The sound and tone is great. I then bolted it onto a 212cc Predator Ghost. It was quite a bit louder on the Ghost but still tolerable. I can't compare before and after on the Ghost since I never tried the Harbor Freight pipe before going to this one. I am happy with it and recommend it to anyone looking for a quality pipe for their minibike.