Product Description
Engine Riser Kit for small block engines to help raise the engine 1" away from the motor mount, give enough clearance to use a Torque Converter.
Includes (2) 1" x 1" square tube and hardware to mount.
Fits 4-7 HP engines with 3-1/8" center spacing.
Bolts: 5/16" x 2.5" Fine Thread
Product Videos
Custom Field
Product Reviews
76 Reviews Hide Reviews Show Reviews
-
Riser...
Not really a bad review but if you have a motovox don’t buy because it won’t fit you would need 2 and a half or 3 inches maybe 3 in a half inch riser unless you want to cut your frame up but over all great quality
-
Riser...
If you have a motovox trying to put on torque converter do not buy it will not fit
-
Better than doing it...
I was gonna make the risers myself but seen on YouTube about them. I ordered them and they was still a hair too short so I had to hammer some of my mount down. Over all I'm happy. 2019 Colman 200ex-r
-
Wish they had these in 1/2"
Bought the 1" riser doesn't work well with my go kart. Not a issue with the product. Wish I knew my chain on the dead axle wouldn't take the 1" well. I always get the chain stretch, then I have to max the slide clearance, then it stretches more, if I take a link out to the solid link then I'm to short on just the plate. Was hoping 1" would do it, 1/2" chain slack on both sides, but that don't equal an inch lift. Only a 1/2" lift.
-
Great...
Parts arrived fast! Parts were as advertised and easy to install. Thanks fellas
-
Engine...
Very good product. They do the job.
-
Engine Riser...
Engine Riser Kit
-
It fit...
It fit perfectly
-
Good
They fit perfect
-
A little upset.
I was already upset at the elevated price of 10 inches of 1" square tube and 4 bolts and nuts. When the parts came, they were covered in shop grease and dirt.