10" GPS Machined Aluminum Front Wheel For Fat Tire Minibikes, 220MM Brake Disc

We are thrilled to help you up your minibike game with our 10" GPS Machined Aluminum Front Wheel For Fat Tire Minibikes, 220mm Brake Disc. The perfect upgrade for cruising, racing, and impressing the homies. This set up was designed specifically for the Trailmaster MB200 series, the Mega Moto 212, and some Coleman minibikes but will fit a wide range of large minibikes. Please pay attention to included items, recommended items, and fitment.

Includes:

• 10" machined aluminum rear wheel and hub
• Brake disc spacer
• Sprocket spacer
• 220mm off-set brake disc
• 6201 bearings in the original hub (bearings for spacers are not included)
• Crush sleeve in the original hub
• Valve stem

Dimensions:

• 10" x 3.5" Wheel (bead to bead)
• Brake Disc Diameter - 220mm
• Overall Width - 7.9"

Recommended Items:

• 12mm ID bearing
• 15mm ID bearing

Fitment:

• The bolt on spacers accept 32mm OD bearings (not included). You must run bearings in the spacers or risk bending the axles.
• 12mm ID bearing
• 15mm ID bearing
• Trailmaster MB200 series
• This set up is to be used with our Premium Front Suspension Kit. If you have a stock front end, you will have to extend the caliper mounts to accommodate the large 220mm brake disc.
• Make your own axle spacers / washers. We sell a wide variety of axle spacers in various lengths.
• Brake caliper may need spacers / washers for alignment.
• Mega Moto 212
• This set up is to be used with our Premium Front Suspension Kit. If you have a stock front end, you will have to extend the caliper mounts to accommodate the large 220mm brake disc.
• Make your own axle spacers / washers. We sell a wide variety of axle spacers in various lengths.
• Brake caliper may need spacers / washers for alignment. 
• You can run 4 bearings or just the outside 2 bearings in the spacers. 4 is recommended but it is easier to make your crush sleeve with 2 bearings.
• Wheel and hub come assembled but the bolts are not tightened. Blue loctite and lock washers are recommended.
• Blue loctite is strongly recommended on all bolts.