Outlaw Karts

1/4" Lightweight Right Front Ultra Free Wheel Hub

 Stepped Right Front Wheel Hub w/ 1/4″ bolt pattern. Comes with 1/4″ Easy Start Wheel Studs & nuts, 1- 5/8″ & 1-3/4″ bearing & crush spacer.

5/16" Ultra Light Front Wheel Hub

Left Front Wheel Hub w/ 5/16″ bolt pattern. Comes with 5/16″ Easy Start Wheel Studs & nuts, 2- 5/8″ bearings and crush spacer.

15 Degree American Slide Motor Mount

-Ultra-lightweight sliding adjustable motor mounts.-American Spacing- 2-7/8″ from center to center of frame rails.-American mounts fit on 1-1/4″ Frame Rails.-Black Oxide or Zinc Plated Steel Clamps (depending on what is in stock at time)

Aluminum Tie Rod

3/8″ tubular aluminum tie rods with wrench flats; black anodized finish Ends sold separately  

1" JR Pedal Kit

Adjustable to accommodate most drivers, this Jr. pedal kit fits most karts by clamping on the 1'' front bumper slugs. Includes a brake & throttle rod, foot plates and mounting brackets. Brake & gas pedals sold separately, can use billet or...

Hilliard Fire Clutch

The Hilliard FIRE has a bonded high-performance friction lining on the shoes that makes a smooth transition from the slip you need for optimal acceleration off the corners. The clutch includes a special oil & grease shield to keep contamination off...

11 Tooth Driver For Hilliard

Only fits the Hilliard drum fits 35 chain Recommended Items: Hilliard (PC-7520)

Slide Motor Mount Bolt Kit

This kit is for standard slider plate and has all the screws & nuts you’ll need.

1/2-20 Castle Nut

1/2-20 Kingpin nut

5/8"ID x 1/8" Black Wheel Spacer

1/8" thick x 5/8 ID black wheel spacer Made of Aluminum

5/8"ID x 1/2" Black Wheel Spacer

1/2" thick x 5/8 ID black wheel spacer Made of Aluminum

Kingpin Bolt

1/2 x 3.75

1-1/4 Lightweight 4 Bolt Hub, 3" Bolt Pattern

4 bolt hub for brake disc and sprockets. Dimensions: Fits over 1.25" Axles 4 Bolt Circle Pattern of 3" 1/4" Keyway Comes with Pinch Bolt

11 Tooth 2 Prong Clutch Sprocket

To be used with no center shaft  11 tooth with bearing to be mounted in board

5/8"ID x 1/4" Black Wheel Spacer

1/4" thick, 5/8 ID Black wheel spacer Made of aluminum

3/4"ID x 1/8" Black Wheel Spacer

1/8" thick x 3/4" ID Black wheel spacer Made of aluminum

Tie Rod End

Right or left 3/8-24 Comes w/ jam nut, each

Thick Kingpin Washer

1/2 ID x 7/8 OD x 1/4 Thick Steel Zinc Plated

Motor Mount Stud

5/16 - 18 x 1 3/4", Sold each

Stepped Aluminum Clutch Washer

Stepped, Aluminum, Clutch Washer